Zero-Turn Mower Repair Serving Belle Plaine — Cologne Shop
Swedlund's Lawn & Power Sports serves Belle Plaine and the surrounding Scott County area, where acreage and rural residential properties make zero-turn mowers a common tool. Our current shop is at 106 Louis Street West, Cologne, MN 55322. If your mower pulls to one side, the deck won't engage, or it simply won't start, call to arrange drop-off by appointment and we'll diagnose it before quoting. We've worked on Hustler, Ferris, Toro, Cub Cadet, Scag, and Gravely machines alongside major residential brands like Husqvarna and John Deere.
Equipment We Service
- Hustler and Ferris commercial-grade zero-turns
- Toro TimeCutter and Titan series
- Husqvarna zero-turn mowers
- John Deere Z-series
- Cub Cadet Ultima and RZT series
- Scag and Gravely commercial zero-turns
- Ariens APEX and Edge series
Common Symptoms
- Pulls or drifts to one side when both lap bars are even
- Deck won't engage or disengages under load
- Won't start — battery good but no crank
- Slow or sluggish on hills
- Battery dies repeatedly after use
- Belt squealing or slipping off pulleys
- Rough engine idle or hard starting
Why Diagnosis Matters
Zero-turn mowers have interdependent systems — a pull-to-one-side issue can be a lap bar adjustment, a worn drive belt, low hydrostatic fluid, or a failing transaxle. Treating the symptom without diagnosing the cause leads to repeat failures. We test each system before recommending any repair.
Drop-Off & Pickup
We serve Belle Plaine from our Cologne shop at 106 Louis Street West, Cologne, MN 55322. Call 612-816-8013 to arrange drop-off by appointment or ask about pickup if the machine can't be trailered.
Frequently Asked Questions
Do I need an appointment to drop off my zero-turn mower?
Our shop is at 106 Louis Street West, Cologne, MN 55322. Contact us at 612-816-8013 to coordinate drop-off and get an estimate of when we can look at it.
My zero-turn mower pulls to one side. What causes that?
A zero-turn that drifts or pulls even when both lap bars are in the same position almost always has a hydrostatic drive problem on one side — not a tire issue. The cause could be a worn drive belt, low or degraded hydrostatic fluid, a lap bar adjustment issue, or a failing transaxle. Each requires different diagnosis and a different repair. We test each system before recommending anything.
Is it worth repairing an older zero-turn mower?
It depends on the machine's condition and the repair cost. A well-maintained Husqvarna or Ferris zero-turn can last 15–20 years with proper care. If the repair is a belt, blade, or carb issue on a solid machine, it's almost always worth it. If the transaxle on both sides is failing on a 12-year-old economy unit, the math may not work. We'll give you an honest assessment — we don't have an interest in selling you a new mower.
What brands of zero-turn mowers do you work on?
We service most major brands including Husqvarna, John Deere, Cub Cadet, Toro, Ariens, Ferris, Hustler, Scag, Gravely, Bad Boy, and others. If you have a question about a specific model, call us at 612-816-8013 before bringing it in.
What does a zero-turn tune-up include?
A standard tune-up covers oil and filter change, air filter replacement, spark plug replacement, blade inspection or sharpening, belt condition check, deck leveling, hydrostatic fluid check, and a full operational test. We document what was done so you have a service history on the machine.
Related service: Zero-Turn Mower Repair